Technical Specifications

AC Input

100 – 230 V AC ± 15% ; 50 / 60 Hz without adjustment.

Power Consumption

< 70 VA

Battery Type

Rechargeable Sealed Lead Acid 12V, 4.5AH

Battery Capacity

More than 100 discharges of 300 Joules (With new and fully charged battery)

Battery Charging Time

Approx. 3 hours to 90% of full capacity. 18 hours to 100% capacity

Dimensions

260mm (W) x 280mm (D) x 250mm (H)

Weight

< 10.5 Kg. (including battery, external paddles)

Environmental

Operating Temperature

0 to 400C

Temperature

-10 to 60, -10 to 70 (DF 2617 AED/R)

Relative Humidity

15 to 95% non condensing, 30- 95% (DF 2617 AED/R

Relative Humidity (Storage)

15 to 95% non condensing

Standards

Classification

Class 1 with internal power supply as per IEC 60601-1

Degree of Protection

ECG Input

Type CF

Paddle Input

Type BF

Defibrillator

Defibrillator Waveform

Current controlled Biphasic Waveform

Energy Selection

2 – 300 Joules in steps of 2, 3, 5, 7, 10, 20, 30, 50, 70, 100, 150, 200, 250, 300 Joules

Energy Select Controls

Keys on front panel

Paddle Assembly

Detachable type external paddle assembly with coiled high voltage cable. Adult and Paediatric paddles integrated into same handle

Charge Control

Momentary CHARGE key on the front panel and on the APEX paddle.

Charge Ready Indication

Charge done LED on the front panel CHARGE key and Charge done LED on the APEX paddle. Charge done tone, which can be disabled by user

Disarm Control

Pressing ENERGY SELECT control after charging has started. Automatic disarm after 60 seconds from charge ready, if shock is not delivered

Synchroniser

Energy delivered within 50mSec. of detected R wave peak. SYNC message displayed on screen. SYNC LED illuminates in Sync mode and blinks during each detected QRS wave. Sync marker appears on bothscreen and recorder strip.

Delivered Energy

Delivered energy displayed on the screen after each shock. Actual patient impedance is displayed on the screen during shock

Charge Time

300 Joules in less than 10 seconds with fully charged new battery.

Monitor

Display Size

5.7” STN LCD Display

Sweep Speed

25 ± 1 mm/sec

ECG Input Modes

ECG input through paddles or 3 lead patient cable

User Gain Settings

8 level setting: x0.25, 0.5, 0.75, 1.0,
1.5, 2.0, 3.0 & 4.0

1mV Calibration

A vertical bar line is displayed
continuously at the left end of trace.
The height varies with gain setting
and indicates height of 1mV signal.

Reset Recovery

Automatic recovery of waveform
within 0.5 seconds after electrical
overload or defibrillation.

CMRR

> 90 dB @ 50 Hz

Input Impedance

> 2.5 M Ohms

Frequency Response

e 0.5-35 Hz

Heart Rate Display

10 to 300 BPM

Heart Rate Accuracy

±2 BPM or ±2% whichever is higher

Heart Rate Alarms

Audible tone is generated if HR
limits are violated.
Three sets of high and low alarm
limits are available.
The limits are configurable in the
setup menu from 20-300 BPM in
steps of 1BPM

QRS Tone

User adjustable audible tone with every detection of QRS

Alarm / Alert Tone

e User adjustable audible tone for
alert message and HR alarm

ECG Out

1V/mV

Defibrillator Protection

Yes

Freeze

Yes (In models without recorder) Freezes the ECG trace on the screen. MARK key is used to FREEZE and remove the FREEZE condition. HR display and Alarm limits will be still active

AED (applicable in DF 2617 AED/R)

Energy @ 50 Ω

Adult: 200J- 300J

Waveform

Current control Biphasic Waveform

Preset Energy

Lo=200J, Hi=300J (Programmable
Patterns for initial 3 Shocks)

AED Mode Select Controls

Momentary AED ON/OFF key on
front panel to enter/exit AED mode

Charge Ready Indication

Display/Voice command

Printer (Optional)

Paper Speed

25 ± 1 mm /Sec

Paper Size and Type

Thermal paper in rolls. 50 mm width,
20 meters.

Print Width

40mm

Print Channel

1

Event Recording

Stores and prints 3 seconds of pre critical data and 7 seconds post critical event data up to 24 events. Data is retained even after unit is turned off.

Print Annotates

Time, Date,HR, HR Limits, Event
Marker, ECG Input Source, ECG Gain,
Defibrillator Mode, Selected and
Delivered energy, Patient Impedance
and Hospital Name

Recorder Mode

Configurable to print either real time
or 6 seconds delayed ECG.

Standard Accessories

Defibrillator-Paddles (Adult & Paediatric)

1 no.

Disposable Electrodes

1 pkt

Power Cord

1 no.

Accessory Bag

1 no.

Cardijelly

1 no.

Patient Cable

1 no.

User Manual

1 no.

Recording Paper (20M roll)

1 no.